Battery charging
The battery must be fully charged before using the Bluetooth headset for the first time.
1. Connect the charger cable to the charging socket on the headset
3. The indicator light shows red when charging, and when it is fully charged, the red light turns off
2. Insert the charger into the power socket
and the blue light is displayed and the power is automatically cut off, and the charging protection is turned on.
4. Separate charger from headset and power socket
5. Charging completed.
Switch on /off
1. Power on: press and hold the start / end call key for about 3 seconds until the red and blue lights alternate.
2. Shutdown: press and hold the start / end call key for about 6 seconds until it is Closed.
Note: the phone will not be connected immediately after power on. Press the power on button twice continuously to switch between Chinese and English.
Enable headset to connect to phone via Bluetooth
1. Turn on the headset, press and hold the function key for about 5 seconds until the red and blue lights flash alternately.
2. Set the phone to search for Bluetooth devices.
3. When the phone searches for the headset, search to the list to confirm the headset.
4. If the pairing is not successful, repeat the operation, only pairing once.
5. If pairing is successful, the indicator light will turn off, and you can make/receive cals in standby mode and ready state.
Answer the phone
1. Press the answer key on the phone
2. Press the start / end call key on the headset
Hang up the phone
1. Press the hang up key on the phone
2. Press the start / end cal key on the headset
Call telephone
1. Use the phone keypad to enter the call number and press the answer / call key once to automatically transfer the call to the headset.
Refuse to answer
1. Press the hang up key on the phone
2. When the phone rings, press and hold the start / end call key on the headset for about 2 seconds.
Redial last number
1.Click the start / end call button on the headset in standby mode for about 2 seconds.
Up and down switch
1. Press and hold the "volume key on the headset for about 2 seconds, release it to switch to the previous song.
2. Press and hold the "volume key " on the headset for about 2 seconds, release it to switch to the next song.
Adjust headphone volume
1. Press and hold the "volume key +" on the headset to increase the volume.
2. Press and hold the "volume key " on the headset to decrease the volume.
Safety precautions
1. Use headphones when driving, please follow the regulations of your country or region. Do not remove or modify the headset for any reason, otherwise it may cause the headset to malfunction or burn, Please send the headset to an authorized service center for repair.
2. Do not place the equipment in an environment with too low or too high temperature (below O C or above 45 C).
3. Extreme temperature will cause equipment deformation, reduce the charging capacity of the equipment, and shorten the service life of the equipment. Do not wet the equipment, which may cause serious damage to the equipment. Do not touch the equipment with wet hands, The manufacturer will not guarantee the damage caused by water entering the equipment.
4. Do not use the device in thunderstorm weather. Thunderstorms can cause equipment to work abnormally and increase the risk of electric shock.
0 Comments